What transmission fluid do I use in a 700r4

The recommended transmission fluid is Dextron VI, with a capacity of 11 Quarts.

What transmission fluid goes in a 700R4?

The recommended transmission fluid is Dextron VI, with a capacity of 11 Quarts.

What type of transmission fluid does GM take?

DEXRON-VI Automatic Transmission Fluid is suitable for use in vehicles that specify the following requirements: fully licensed and approved by GM, recommended for use in GM transmissions model year 2006 and newer calling for DEXRON-VI Automatic Transmission Fluid (replaces DEXRON-III and DEXRON-II(E), or recommended …

How many quarts of transmission fluid do I need for a 700R4?

Registered. I’m told the 700R4 holds about 11 quarts of fluid. My transmission builder says, “Put 6 quarts in the tranny, run it for about 10 seconds, then add 5 quarts and run it again.”

Does it matter what transmission fluid I use?

It is also important to use the correct type of automatic transmission fluid because different fluids have very different properties. The wrong fluid can cause irregular pressures, clogs, precipitation or corrosion which can all drastically shorten the life of your transmission.

How can you tell a 700R4 from a 4L60?

You can’t tell the difference between a 700R4 and a 4L60E by the oil pan as they are nearly the same. If the transmission has a large 18-pin electronic connector above the passenger side pan rail, it’s a 4L60E, as seen here. If it has a cable connection near the cooler lines on the passenger’s side, that’s a 700R4.

What year 700R4 is best?

Generally, 1987 and up TH700R4s or 1990-’93 4L60 units are the most desirable. Before trying to install this transmission in your vehicle, you should thoroughly check the unit and refurbish it, if necessary.

How much transmission fluid do I put in my torque converter?

When installing the converter onto the transmission, please pour approximately one quart of ATF (automatic transmission fluid) into the converter before installing into the transmission. Using a light grease, coat the transmission seal, front pump bushing, and converter neck.

How much fluid does a 700R4 filter change?

Since we were obviously low before, and we know that the 700R4 will usually take six quarts after a service, we added four, ran the truck up to temperature, checked our dipstick, and continued with process up to six quarts so we would now know exactly how to read on our fancy-if-not-accurate dipstick.

Can I use dexron III instead of dexron VI?

DEXRON-VI can be used in any proportion in past model vehicles equipped with an automatic transmission, in place of DEXRON-III (for instance, topping off the fluid in the event of a repair or fluid change). DEXRON-VI is also compatible with any former version of DEXRON for use in automatic transmissions.

Article first time published on

Is dexron VI transmission fluid synthetic?

Mobil DEXRON-VI ATF is a high performance, synthetic blend formulation that meets or exceeds the stringent requirements of GM’s DEXRON-VI specification and provides warranty protection for 2006 and newer GM vehicles. It also provides improved performance in older GM vehicles, wherever DEXRON is specified.

What transmission fluid is compatible with dexron VI?

Valvoline MaxLife ATF transmission fluid is 100 percent compatible with the DEXRON VI for mixing or flushing a system.

What happens if I use the wrong transmission fluid?

Using the wrong fluid can cause poor lubrication, overheating, and possibly transmission failure. A mechanic might not be able to reverse the damage, even by flushing the transmission. Mistakenly adding motor oil or brake fluid can also destroy your transmission.

Is ATF 4 the same as dexron VI?

ATF+4 has specific additives designed for specific Chrysler transmissions. The additives and the make up of the fluid keeps the transmission working properly. If you put the wrong fluid in at best it won’t shift right, at worst it will ruin the transmission. Dexron is the same thing only for Chevy vehicles.

Can I use ATF instead of CVT?

ATF is used to lubricate and actuate a more conventional transmission consisting of a hydraulic pump, a set of gears, clutch discs and bands. It is not going to do the job with CVT transmissions that are gearless systems of chain-driven or belt-driven conical blocks or pulleys or discs and rollers.

Is the 700R4 computer controlled?

You need to distinguish between the 700-R4 trans (which can be set up to run without a computer) and its later descendent, the 4L60E family (which is a fully electronic, totally computer-controlled transmission).

What does the governor do in a 700R4?

The transmission governor on a 700R4 is used to regulate the speed at which the transmission shifts into the next higher or lower gear. It accomplishes this through the use of two sets of centrifugal weights, each a different weight.

Can you use a 700r4 with a LS motor?

You could use the 700r4 behind a LS motor, but I dont recommend it. I’d sell it and then but a 60e or 80e. Even it if was just rebuilt. The only time that i’d consider running the 700r4 would be if it was a built racing trans which usually runs about $1200.

How many quarts of transmission fluid do I need for a 4 cylinder?

On average, passenger vehicles take between 4 and 17 US quarts (3.8 to 16 liters) of transmission fluid to fill. Green cars and manual-transmission automobiles require the least transmission fluid, while pickup trucks and luxury cars need the most. Regardless of vehicle type, avoid overfilling the transmission.

What is dexron III?

ATF Dexron-III is a premium automatic transmission fluid specially formulated to meet the needs of today’s more compact transmissions, running at higher operating temperatures and with electronic control.

Can you add transmission fluid through dipstick?

Observe markings at end of dipstick. Your dipstick might have two markings for “full”—one warm, one cold. If the automatic transmission fluid level does not come up to the “warm” line, you’ll need to add automatic transmission fluid. Insert long funnel into automatic transmission fluid dipstick hole.

What fluid is in a torque converter?

Instead of using air, the torque converter uses a liquid medium, which cannot be compressed – oil, otherwise known as transmission fluid.

Does transmission fluid circulate through the torque converter?

The fluid circulates in the transmission between two main areas, the pan and the torque converter. When the motor is running the fluid circulates from the pan to the torque converter through the cooler lines to the cooler in the radiator and back to the pan continuously.

Does the transmission pump fluid into the torque converter?

A pump helps achieve torque control that works by sending fluid around the torque converter determined by the rotation of the crankshaft. … The impeller or centrifugal pump effectively flings the transmission fluid into the fins of the turbine that in turn spins or transmits the torque into the transmission.

Do they still make DEXRON III?

Direct Replacement Dexron VI fully replaces Dexron III and prior evolutions of the Dexron fluids. GM manufactured the liquid for compatibility with transmissions requiring earlier versions of the fluid. Dexron VI works in any vehicle that requires ATF-A (the original automatic transmission fluid) or a Dexron variation.

Can you mix transmission fluid with power steering fluid?

No, you can not mix power steering fluid with transmission fluid. Transmission fluid is not made for the same purposes as power steering fluid, so you can’t mix the two without risking your power steering pump and your transmission.

Can I use DEXRON VI for power steering fluid?

While DEXRON VI has / is being used on power steering system in newer vehicles and it “may” work on older models it’s more if the seals and the rest of the system would be able to operate properly and if the entire PS system could be completely drained.

Is all dexron VI the same?

Dex VI is licensed by GM so it has to meet their specs no matter the brand.

What is dexron mercon?

LUBRIPLATE Dexron III/Mercon is a newly developed premium fluid fully qualified to cover current requirements for both General Motors and Ford. Dexron III is a General Motors trademark for qualified automatic transmission fluids. Mercon covers all automatic transmissions for Ford model year 1988 and after.

What replaces dexron II transmission fluid?

Dexron VI replaced Dexron II and III, and can be used in General Motors domestically built or import transmissions that specified Dexron II or Dexron III. Dexron VI is a low viscosity transmission fluid and should also be used with the full synthetic low viscosity transmission fluid.

Can I use dexron IV instead of III?

Per GM, Dexron IV is backwards compatible in Dex III applications, but not anything before.